- Actuators
- Adapters
- Air Blowers
- Air Conditioners
- Air Curtains
- Air Purifiers
- Anemometers
- Axial fans
- Ball Valves
- Belimo
- Blowers
- Brackets
- Brass
- Brazing Rods
- Capacitors
- Carrier Parts
- Clamp Meters
- Cleaning Products
- Coatings
- Compressors
- Condensate Pumps
- Connectors
- Contactors
- Copper Capillary
- Copper Coils
- Copper Straight Tubes
- Copper Strainers
RTM HT-1S Hand Torch
- HVAC / Plumbing
- Automotive
- Disassemble Bolt
- DIY
- Auto Ignition Torch
- Super Turbo Flame
Operating The Air/Fuel Torch:
1. The maximum heat zone is very concentrated. It's located between 15mm to 20mm from the end of the tip. Holding the torch too close or too far from the target will reduce the heating effect.
2. Temperature Control: To reduce the heating effect of the air/ fuel torch, several approaches are recommended:
a. Move the farther away from the target.
b. Use propane fuel instead of MAP/Pro fuel.
c. Use smaller or soldering tips-if not included in your kit, smaller or soldering tips are available as an option.
